Filter
Top Products
CAUTION:
When laser products (such as CD-ROMs, DVD drives, ber optic devices, or transmitters) are
installed, note the following:
• Do not remove the covers. Removing the covers of the laser product could result in exposure to
hazardous laser radiation. There are no serviceable parts inside the device.
• Use of controls or adjustments or performance of procedures other than those specied herein
might result in hazardous radiation exposure.
DANGER
Some laser products contain an embedded Class 3A or Class 3B laser diode. Note the following.
Laser radiation when open. Do not stare into the beam, do not view directly with optical
instruments, and avoid direct exposure to the beam.
Class 1 Laser Product
Laser Klasse 1
Laser Klass 1
Luokan 1 Laserlaite
Appareil A Laser de Classe 1
`
7. Slide the drive into the DVD drive bay until the drive clicks into place.
8. Go to “Completing the FRU replacement” on page 172.
Replacing the virtual media key
To replace the virtual media key, complete the following procedures:
Removing the virtual media key
To remove the virtual media key, complete the following steps:
1. Read the safety information in “Important Safety Information” on page 1 and “Guidelines for trained
service technicians” on page 115.
2. Turn off the server and peripheral devices and disconnect all power cords; then, remove the cover (see
“Removing and installing the cover” on page 119
).
3. Grasp the virtual media key 4 and gently slide it up and off of the mounting tab 2 .
Chapter 6. Replacing FRUs 165