Filter
Top Products
97
System Reboot
Reboot the Switch in software reset. Click
Apply
button to reboot the switch.
System Reboot interface
Panel List
Display the switch panel GUI. When the switch is in stacking status, it display the
slaves panel GUI. When the switch is stand-alone status, it display itself panel GUI.
You can click the port on the panel GUI to check port current information.
Panel list interface
IP Stacking
This function allows switch to stack up to 8 stackable switches as a unit group. When
configuring the stacking function, beware the following points.
Any port on the switch can be used to stack.
Before configuring the stacking function, make sure all stack switches are in the
same network.
When configure stacking function, must configure the master switch first.
After stacking group has set up, all slave switches are configured through master
switch. You still can direct access to slave switch, but all functions are read and
view only.
To remove the switch from stacking group, you must remove the salve switch first.