Filter
Top Products
If necessary, move the left or right tractor to adjust the tractors to the paper width.
Note: If you have trouble moving the right tractor to the paper width, roll the rubber tractor stop out of the
seated position. Move the tractor to the paper width, load the paper, and then lock the right tractor.
10 Close the left and right tractor doors.
11 Replace the ribbon access cover.
12 Move the tractor to align the left margin on the paper with the [A symbol printed on the rear plate.
Note: The distance from the [A symbol to the left edge of the paper determines the width of the left margin.
13 Push the left tractor locking lever down to lock the tractor in place.
14 Remove slack from the paper, and then lock the right locking lever.
15 Open the control panel cover to access layer 2.
16 Press Micro , Micro , or LineFeed to move the paper to the Top-Of-Form you want to use.
17 Press Set TOF to set the Top-Of-Form.
Note: Top-Of-Form is not saved if the printer is turned off or runs out of paper when using the pull tractor.
18 Make sure the printer is online, and the Ready light is on solid.
Note: If not, press Start/Stop until the Ready light is on solid.
Loading paper
36