Filter
Top Products
3-2 Service Manual
4036-304
Maintenance Tools
The following table describes the tools necessary for the maintenance of this scanner.
Removals
Parts Replacement
1. Clean the disassembly and assembly location.
2. Turn off the power switch and remove the AC plug from the outlet before
disassembly and assembly.
3. Follow the disassembly and assembly procedures. Never loosen the screws of parts
that must not be disassembled. These screws have a red coating.
4. Store the disassembled parts in a clean place to avoid loss.
5. After replacement, check the contacts and spare part mounting.
6. Assemble in the reverse order of disassembly.
Name Description
Flathead screwdriver Idler pulley module screw
Phillips screwdriver (magnetic) Nominal No.2 M3, M4
Nut driver 6 mm
Digital voltmeter With 0.01 V range
Chip Puller Puller for main scanner board chip