Filter
Top Products
Chapter 3: Using the Operator Panel
48
Using the Operator Panel
One Second Tear-Off
When Auto Tear-Off is set to one second, continuous form paper
automatically advances to the tear-off position if a print job ends and no
data is received within one second of the last data transmission. For more
information, see “Auto Tear-Off (Set to One Second)” on page 80.
Manual Tear-Off (Auto Tear-Off Set to Off)
When Auto Tear-Off is set to Off, you can manually advance the
perforation of a continuous form to the tear-off position by pressing Tear
Off, assuming the print position is still on the same page. To set Auto
Tear-Off to Off, see “Auto Tear-Off (Set to Off)” on page 80.
Setting AutoGap
The AutoGap function determines the amount of space that the printer
places between the printhead and the paper. You can select On, Off, or
Single AutoGap from the function menu.
AutoGap Set to On
When AutoGap is set to On, the printer automatically sets itself to the
thickness of the paper you are using. To set AutoGap On, press:
1 Menu.
2 Item ↓ until AutoGap appears.
3 Next
→
.
4 Item ↓ or Item ↑ until On appears.
5 Store to save the setting.
6 Quit to exit the function menu.