Filter
Top Products
Chapter 3: Using the Operator Panel
50
Using the Operator Panel
Manual AutoGap Settings
AutoGap Set to Single
When AutoGap is set to Single, the printer sets the gap between the
printhead and the paper only once. This should only be used when
printing on several cut sheets of the same thickness while using the Auto
Sheet Feeder. The printer adjusts the printhead to the paper’s thickness
when you turn the printer on or when the paper select lever is changed.
There are two Single AutoGap options:
• Open (factory default) means that the printhead moves out of the way
as each sheet of paper is loaded. This setting reduces paper jams.
• Fixed means that once the gap is set, the printhead does not move.
Paper
Type
Paper
Thickness
Weight of Paper
Manual
Setting
Single Forms
(Single Sheets or
Continuous Forms)
Thin 45.1 g/m
2
(12 lb)
56.25 g/m
2
(15 lb)
1
Normal 67.5 g/m
2
(18 lb)
75 g/m
2
(20 lb)
1 or 2
Thick 90 g/m
2
(24 lb) 2
Multiple-Part Forms
When the setting is
4 or higher,
printing speed
becomes slower.
__ 2 Part Form 2 or 3
3 Part Form 3 or 4
4 Part Form 4 or 5
5 Part Form 5 or 6
6 Part Form 5, 6, or 7
Envelopes 4, 5, or 6