Filter
Top Products
77
Chapter 4: Selecting and Loading Paper
Selecting and Loading Paper
6 Press Menu. Set Top of Form appears on the display.
7
Press any paper movement key (Micro ↓, Micro ↑, or
LineFeed) to move the paper to the position you want.
The following illustration shows the printer without the
ribbon cartridge installed. When the cartridge is not installed,
you can easily see the position of the two horizontal white
lines on either end of the metal platen bar. Use these lines as
your reference point when lining up your TOF. The bottom of
a printed character will be even with the white lines.
Note: When the ribbon cartridge is installed and the top edge
of the paper is even with the top edge of the ribbon, the
TOF is set to one line, or 1/6 inch.
8
Press Store to save the position you want. The Ready light
comes on solid.
Whenever you change the TOF setting, tear off excess continuous
forms, then unload and reload the paper by pressing Load/
Unload. This ensures the printer goes to the current TOF setting.
Note: When Auto Tear-Off is set to On, the paper advances to the
current tear off position. If the tear off position is not correct,
see “Auto Tear-Off (Set to On)” on page 79.
White lines