Filter
Top Products
21
Installing an option card Your printer has two connectors that support the
following option cards:
• Hard disk with adapter card
• MarkNet™ internal print server
• USB/Parallel 1284-C Interface Card
• Parallel 1284-C Interface Card
• Coax/Twinax Adapter for SCS
• Tri-Por t Adapter
Refer to the documentation included with each
card for detailed information about that specific
card.
You need a small Phillips screwdriver to install
these options.
Note: The Lexmark T622n model ships with an
Ethernet print server already installed.
Warning!
Electronic components are easily damaged by
static electricity. Touch something metal on the
printer before you touch the card.
1 Follow the steps in “Accessing the printer
system board” beginning on page 17.
2 Locate the card connectors on the system
board. If you are installing only one card,
install it in connector 1. If you are installing
two cards on a model with multiple
connectors, use connector 1 first and then
connector 2.
3 Locate the two screws on the back of the
printer that attach the metal plate to the slot.
4 Remove and save the two screws. Remove
and discard the plate.
5 Unpack the card. Save the packaging
materials.
MarkNet internal print server
Tri-Port adapter
hard disk with adapter
USB/Parallel 1284-C interface card
MarkNet N2501e or N2401e
Connector 1
Connector 2