Filter
Top Products
30
Verifying the IP
settings
1 Print another network setup page and make sure the IP Address, Netmask,
and Gateway are what you expected.
Use the information in “Printing a network setup page” on page 27 if you
need help.
2 Ping the printer and verify that it responds.
For example, at a command prompt on a network computer type “ping” fol-
lowed by the new printer IP address:
ping xxx.xxx.xxx.xx
If the printer is active on the network, you should receive a reply.
Configure for Pull
Printing
(ImageQuick)
If your printer has an ImageQuick™ optional firmware card installed, you can con-
figure for Pull Printing once an IP address has been assigned to your printer.
For detailed configuration instructions, refer to the online documentation on the
ImageQuick CD. The ImageQuick CD is shipped with printers that have the
ImageQuick optional firmware card pre-installed, and also with the firmware card if
you purchased it separately.