Filter
Top Products
22
6
Align the connection points on the card with
the connector on the system board and push
the card firmly into the system board
connector.
7 Insert the two screws saved from the metal
plate (or the extra screws shipped with the
card) into the holes.
8 Tighten the screws to secure the card.
Reattaching the shield and closing
the doors
After you have installed option cards on the printer
system board, follow these steps to reattach the
shield and close the doors.
1 Grasp the shield by the tabs and align the
three keyholes on the shield with the top
three screws. Holding the shield by the tabs,
slide it down onto the screws. Tighten all six
screws.
2 Close the side door.
3 Close the upper and lower front doors.
Note: If you have not completed the section
“Setting up the printer” beginning on
page 7, do so now.
Tabs