Filter
Top Products
Select To
Allow user to create folder Let users create a subfolder within the destination folder and save their scan job.
Start in username folder
(create if it doesn't exist)
Save each user's scanned documents in a subfolder named for their user name within the
destination folder.
Scan Confirmation Page
Select To
Include Thumbnail Include a thumbnail of only the first page, all pages, or none at all (Off) with the scan confirmation
page.
Print Confirmation
Page
Determine if a confirmation page will be printed after a scan job. Select Allow User to Choose to let
the user choose whether to print a confirmation page or not.
Email Confirmation E‑mail a confirmation page. To include the status of the associated scan in the subject line of the e-
mail message, select Append scan status to Subject line.
Note: When Email Confirmation is used, the scanner must be configured to use an e-mail server.
For more information, see the documentation that came with your scanner.
Configuring LDAP
If your network uses LDAP, then the scanner may be required to connect to the LDAP authentication server to retrieve
network share or FTP path information for network destinations.
Notes:
• If your scanner has been configured to use LDAP authentication for user access, then some or all of the needed
settings may have been configured previously.
• Modifying or deleting an existing LDAP profile can affect user access to the scanner or to individual scanner
functions.
Address Book Setup
1 From the Embedded Web Server, click Settings > Security > Security Setup.
2 In the Advanced Security Setup section, click LDAP > Address Book Setup.
3 Configure or verify the following settings:
• Server Address—This is the IP address or host name of the LDAP server where authentication will be performed.
• Server Port—This is the port number the Embedded Web Server will use to communicate with the LDAP server.
The default port is 389.
• Use SSL/TLS—Make sure you select None for this setting.
• LDAP Certificate Verification—Make sure you Select Allow for this setting.
• Use GSSAPI—Make sure the check box is cleared.
• Mail Attribute—This is the mail attribute of the LDAP server.
• Search Base—This is the search base used on the LDAP server.
Configuring Scan to Network 11