Lexmark MX711DE Printer User Manual


 
Have bent corners.
Have rough, cockle, or laid finishes.
Adjust the width guides to fit the width of the envelopes.
Before loading the envelopes on the tray, flex the stack of envelopes back and forth to loosen them, and
then fan them. Straighten the edges on a level surface.
Note: A combination of high humidity (over 60%) and high printing temperature may wrinkle or seal envelopes.
Tips on using labels
From the printer control panel, set the paper size, type, texture, and weight in the Paper menu to match the labels
loaded in the tray.
Print samples on labels being considered for use before buying large quantities.
For more information on label printing, characteristics, and design, see the Card Stock & Label Guide at
http://support.lexmark.com.
Use labels designed specifically for laser printers.
Do not use labels with slick backing material.
Use full label sheets. Partial sheets may cause labels to peel off during printing, resulting in a jam. Partial sheets
also contaminate the printer and the cartridge with adhesive, and could void the printer and toner cartridge
warranties.
Do not use labels with exposed adhesive.
Before loading labels on the tray, flex and fan labels to loosen them. Straighten the edges on a level surface.
Tips on using letterhead
Use letterhead designed specifically for laser printers.
Print samples on the letterhead being considered for use before buying large quantities.
Before loading letterhead, flex and fan the sheets to prevent them from sticking together.
Page orientation is important when printing on letterhead.
Source Printing Printable side Paper orientation
Trays Onesided Facedown Load the sheet with the
top edge toward the front
of the tray.
Trays Twosided Faceup Load the sheet with the
bottom edge entering the
printer first.
Multipurpose feeder Onesided Faceup Load the sheet with the
top edge entering the
printer first.
Multipurpose feeder Twosided Facedown Load the sheet with the
bottom edge entering the
printer first.
Note: Check with the manufacturer or vendor to determine whether the preprinted letterhead is acceptable for laser
printers.
Paper and specialty media guide 86