Filter
Top Products
POD Farm 1.01 – Using Your Line 6 Hardware
2•3
UX1 (POD Studio & TonePort)
Connect a microphone
Connect your electric guitar or bass
Connect your stereo headphones
Mic - To input a signal from a microphone, connect it here using an XLR cable. When in POD Farm
Standalone operation, this inputs the microphone signal into POD Farm, where you can choose your
Tone, and then route the processed signal both to the Record Sends (to your audio software) and
directly to the UX1 hardware outputs.
Instrument Input - To input your electric guitar or bass, plug it in here using a standard 1/4-inch TS
instrument cable. When in POD Farm Standalone operation, this inputs the signal into POD Farm
where you can choose your tone, and then route the processed signal both to the Record Sends (to your
audio software) and directly to the UX1 hardware outputs.
Phones - If you want to listen to the audio from UX1 using stereo headphones, then plug them into this
1/4-inch stereo jack. This headphone jack outputs the same signal fed to the Analog Outs on the rear
panel; the audio from your audio software, as well as anything plugged into any front panel input.
Connect any line level input
source that you want to record
into the Line Inputs
Connect any line level input
source for monitoring to the Stereo
Monitor In
Connect a USB cable from here to
your computer’s USB port
Connect the Analog Outs
to your audio monitors
Line Inputs - To record the signal from a line level source, such as a keyboard, your stereo receiver,
the line out from a mixing console, etc., connect to these Left and Right ins using 1/4-inch TS audio
cables.