Filter
Top Products
27
PrintServer for USB with 4-Port Switch
Chapter 8: Bi-Admin Management
Overview
Chapter 8: Bi-Admin Management
Overview
The PrintServer is managed by a utility program called Bi-Admin on the PrintServer’s Setup CD. Fully compatible
with Windows 98, Me, 2000, and XP, Bi-Admin allows you to change the PrintServer’s internal settings, check on
the unit’s status, and perform basic diagnostic tests. Note that the Bi-Admin program must be installed only on
the network administrator’s computer. First, you will install Bi-Admin on your computer. Then, you will be able to
use the management utility.
Bi-Admin Installation
1. If you haven’t already done so, insert the Setup CD-ROM into the computer’s CD-ROM drive. The Setup CD-
ROM should run automatically. If it does not, click the Start button and choose Run. In the box that appears,
enter D:\setupWizard.exe (if “D” is the letter of your CD-ROM drive).
2. When you see Figure 8-1, click Bi-Admin Install to continue. Click Exit to end the installation.
3. The Welcome screen of the Bi-Admin Setup program, Figure 8-2, will appear first. You will need to close any
other programs you have open before you continue. Click Cancel to quit the setup program, then close the
open programs. Click Next to continue with the Bi-Admin installation.
Figure 8-2: Bi-Admin Setup Welcome
Figure 8-1: Welcome