Filter
Top Products
Chapter 4
Configuration Using the Web-based Utility
17
Business Series Smart Gigabit Ethernet Switch
Port Management > LACP
In addition to LAGs that you create by manually grouping
ports together, you can also use the Link Aggregation
Control Protocol (LACP) to automatically negotiate a LAG
link between the Switch and another network device.
The LACP screen contains fields for configuring LACP LAGs.
This screen is divided into three parts: Global Parameter,
Port Priority, and LACP Port Table.
Port Management > LACP
Global Parameter
LACP System Priority The global LACP priority value,
from 1 to 65535. The default value is 1.
Port Priority
Port The port number to which the timeout and priority
values are assigned. To configure a different port, select it
from the drop-down menu. If you do not see the port you
want, click Next in the LACP Port Table.
LACP Port Priority Defines the LACP priority value for
the port, from 1 to 65535. The default value is 1.
LACP Timeout The administrative LACP timeout value.
Select either Short or Long (default).
Admin Key (Read-only) A channel will only be formed
between ports with the same admin key. This only applies
to ports located on the same switch.
When you are finished entering the settings above, click
Update to apply the settings.
LACP Port Table
This section provides a read-only display of the current
LACP settings.
After you are finished setting the LACP parameters,
click Save Settings to save the settings, or click Cancel
Changes to cancel your changes.
Port Management > PoE Power Settings
NOTE: This section applies ONLY to the
SLM224P and SLM248P Smart Switches.
The PoE Power Settings screen allows you to configure the
Power over Ethernet (PoE) ports on the Switch.
Port Management > PoE Power Settings
Port Displays the port number.
Admin Status Check the checkbox to enable PoE power
to be supplied to the connected device.
Priority Select Critical, High, or Low (default) from the
drop-down menu to set the priority of the port.
Power Allocation (milliwatts) Sets the maximum power
in milliwatts that can be supplied to the port.
Power Consumption (milliwatts) Displays the power
currently being used by the connected PoE device.
Click Save Settings to save the changes, or click Cancel
Changes to cancel your changes.