Filter
Top Products
10
ENGLISH
INITIAL SETTING
1. Connect the mains cord to the projector. Connect the other end to a wall outlet.
Turn on the main power switch. The Power LED blinks (blue) slowly.
2. Remove the lens cover.
3. Turn on the connected devices.
4. Press the ON button on the remote controller to turn on the projector.
The Power LED lights blue and the projector splash screen displays.
5. Press the INPUT 3 or INPUT 4 key to select the input signal source.
Turning on the Power
1. Use the ZOOM ring (on the projector) to resize the projected image and screen size.
2. Use the FOCUS ring (on the projector) to sharpen the projected image.
3. Press MENU on the remote control to open the OSD.
4. Press 34 to select Config. and then press ENTER.
5. Press 12to adjust the horizontal keystone and then press ENTER.
6. Press 12to adjust the vertical keystone and then press ENTER.
7. Press the EXIT button twice to close the OSD.
Adjust the Zoom, Focus and Keystone
STANDBY
ON
C1 C2 S F
DV1 RGB V N
THTR
STD DYN Z1
HB CT Z2
LB
COMP.1 COMP.2 S VIDEO FULL
DVI RGB VIDEO NORMAL
THEATER STANDARD DYNAMIC ZOOM1
LOW HIGH-BRIGHT-
C-TEMP ZOOM2
INPUT
V-MUTE MENU
FREEZE
CON
-
ON/OFF
INPUT
PIP
SWAP MENU
CON
+
BRI
-
BRI
+
EXIT
E
M
F
CONTRAST BRIGHTNESS
FOCUS RING
ZOOM RING
INPUT
V-MUTE MENU
FREEZE
PIP
EXIT
E
M
F
3
7
4
5, 6