Filter
Top Products
4
ENGLISH
Rear and Terminals View
z
v
bnm,.
⁄0
⁄1
⁄2
xc
z S-VIDEO IN
Connect an S-video enabled device.
x VIDEO IN
Connect a composite video enabled device.
c COMPONENT VIDEO IN 1
Connect a component video enabled device.
v COMPONENT VIDEO IN 2
Connect a component video enabled device.
b RGB IN
Connect to a computer.
n DVI-D IN
Connect a DVI (digital) cable from a computer
or video source.
m RS-232C
This is a service port for firmware upgrades.
, TRIGGER 1
Connect to the screen.
When the unit is turned on, 12V is output.
When the unit is turned off, no voltage is
output. This allows such as a powered
up/down screen,whenever the projector is
turned on or off.
Note:
To connect with external devices, use
an ordinal 3.5mm mini-plug (mono)
cable.
. TRIGGER 2
Connect to the screen to control screen
aspect ratio with powered up/down dual
aspect ratio screen. If Normal (4:3) aspect
ratio is selected by projector, 12V is output.
Notes:
•
Do not use TRIGGER 1 and TRIGGER
2, as the power source.
•
To connect with external devices, use
an ordinal 3.5mm mini-plug (mono)
cable.
⁄0 IR receiver
Rear receiver for IR signal from remote
control.
⁄1 Main power switch
Turns the main power to the unit on or off.
⁄2 AC IN socket
Connect to an electrical outlet.
Note:
•
If your video equipment has both S-
video and RCA jacks (composite video)
connect to the S-video connector.
S-video provides a better quality signal.