44 Peripheral Equipment cards
-
Relays line status information to the processor
-
Decodes line control information from the processor
Note:
QPC63F or later vintage is required.
Quantity-One
for each network loop connected to the RPE Module at the
local equipment location
QPC65 Rernote Peripheral Switch
System Hardware-System
option
21/51/61/71
Purpose-Used for RPE applications. Performs the following functions:
-
Module, card, and line enables plus the bypass bit to the modules it
serves at the remote site,
-
Cyclic scanning of the terminals it serves for incoming signaling
messages
-
Monitoring of time slot 0 for outgoing messages
-
Assembling incoming messages
Note:
QPC65G or later vintage is required.
Quantity--One
per network loop
QPC66 2M Baud Converter
System Hardware-System
option
21/S/61/71
Purpose-Used
for RPE applications. Converts two carrier loops in to an
Meridian 1 loop.
Note: QPC66E or later vintage is required.
Quantity-Two required for each network loop, one in the local module
and one in the remote module.
Equipment identification and ordering information 553-3001-154