Mitsubishi Electronics HC7800DW Projector User Manual


  Open as PDF
of 61
 
EN-32
INSTALLATION menu
IMAGE
REVERSE
OFF
OFF
BACK COLOR
OFF
LOWLAMP MODE
STANDARDSTANDBY MODE
AUTO POWER
ON
AUTO POWER
OFF
INSTALLATION
TRIGGER1(POWER)
OFF
TRIGGER2(ANAMO)
OFF
ON
ON
BLUE
SPLASH
SCREEN
TEST PATTERN
CROSS HATCH
KEYSTONE0
opt.
ITEM SETTING FUNCTION
KEYSTONE ±15 Use to correct vertical keystone distortion.
LAMP MODE STANDARD Select this option when you want to view images in a well-lit room.
LOW Select to moderate the intensity of the lamp. The fan operating sound is
reduced and the lamp lifetime becomes longer.
STANDBY MODE
STANDARD Select this option when you control the projector via LAN during power
standby.
LOW Select this option when you don’t control the projector via LAN during
power standby. This option disables the LAN terminal and reduces the
power consumption during the power standby.
AUTO POWER ON
ON / OFF When ON is chosen, the lamp is automatically lit when the power cord is
plugged in the wall outlet. Choose ON when using the projector mounted on
the ceiling.
• The projector is in the stand-by mode when the lamp is off. Use the
remote control to turn on the lamp.
AUTO POWER OFF
OFF / 5 - 60min Use to set the time elapsed before the projector enters the stand-by mode
when there is no signal input from the source.
SPLASH SCREEN
ON / OFF Choose ON to display the splash screen when the power is turned on.
BACK COLOR BLUE / BLACK Use to change the color of the screen that appears when no signal is
supplied.
IMAGE REVERSE
OFF Select when viewing images from the front with the projector installed on
the floor.
MIRROR Select when viewing images projected from the behind of the screen with
the projector installed on the floor.
INVERT Select when viewing images projected from the behind of the screen with
the projector installed on the ceiling.
MIRROR INVERT Select when viewing images from the front with the projector installed on
the ceiling.
TRIGGER1(POWER)
ON / OFF The trigger output signal (12 V) is output from the TRIGGER 1 terminal when
the lamp illuminates.
TRIGGER2(ANAMO)
ON / OFF
The trigger output signal (12 V) is output from the TRIGGER 2 terminal when
the aspect ratio is set to ANAMORPHIC 1 or ANAMORPHIC 2.
TEST PATTERN
CROSS HATCH
Select to show the test cross hatch pattern.
WHITE
Select to show the maximum brightness image.
BLACK
Select to show the minimum brightness image.
• WhenLAMPMODEhasbeensettoLOW,thelampmodechangesfromSTANDARDtoLOWaboutoneminute
after turn-on.
• Whenthelampmodeisswitched,theprojectedimagemayicker.Thisisnotaproductmalfunction.
• DonotchangethesettingofLAMPMODEfrequently.
• Tocancelthetestpattern,pressanybutton.
Menu operation (continued)
 previous next