Mitsubishi Electronics HC7800DW Projector User Manual


  Open as PDF
of 61
 
EN-45
6. Enter the NEW NETWORK PASSWORD and
CONFIRM NETWORK PASSWORD.
• Passwordcanbesetusingupto32characters
including alphabets (capital/small) or numeric
characters.
← key: ............. Shifting the position of enter
cursor to the left for each
character.
→ key: ............. Shifting the position of enter
cursor to the right for each
character.
key: ............... Shifting the position of
enter cursor between NEW
NETWORK PASSWORD
and CONFIRM NETWORK
PASSWORD.
DEL key: .......... Deleting the character in the
position of enter cursor for each
character.
caps/CAPS key:
Switching an alphabet character
to CAPITAL or small.
CLEAR key: ..... Deleting all the entered
characters.
7. When NEW NETWORK PASSWORD and CONFIRM
NETWORK PASSWORD are matched, the setting
is completed after changing the NETWORK
PASSWORD.
• WhenyouselectOKandthepasswordsyou
entered are matched, the setting change dialog
is displayed. After the dialog disappears, the
NETWORK menu is displayed.
• WhenyouselectCANCEL,theNETWORKmenu
is displayed without changing the password.
• Iftheenteredcontentisnotmatched,NEW
NETWORK PASSWORD screen appears again
after an error dialog is displayed.
• Itmaytakesometimetoreectthesettings.
IP settings
(See page 29 for menu setting.)
1. Display the NETWORK menu.
2. Press the p or q button to select IP CONFIG.
IP CONFIG
OK
3. Press the ENTER button.
• IPCONFIGmenuappears.
NETWORK
IP CONFIG
1 2
opt.
DHCP
IP ADDRESS
SUBNET MASK
DEFAULT
GATEWAY
0. 0. 0. 0
0. 0. 0. 0
0. 0. 0. 0
MAC ADDRESS
12
ON
Initial network settings (continued)
Setting or clearing DHCP
1. Display the IP CONFIG menu.
2. Press the p or q button to select DHCP.
DHCP
ON
3. Press the ENTER button.
• Conrmationdialogappears.
DHCP :
OK : ENTER CANCEL : MENU
ON
4. Press the t or u button to select ON or OFF .
5. Press the ENTER button.
• WhenyouselectOK,thesettingchangedialog
is displayed. After the dialog disappears, the
NETWORK menu is displayed.
• Tocancelthesetting,presstheMENUbutton.
• Itmaytakesometimetoreectthesettings.
• WhensettingDHCPtoON,IPADDRESS,
SUBNET MASK, and DEFAULT GATEWAY
cannot be set. If you set those settings, set
DHCP to OFF and perform the IP settings as the
following procedures.
IP address settings
1. Display the IP CONFIG menu.
2. Press the p or q button to select IP ADDRESS.
IP ADDRESS
0. 0. 0. 0
3. Press the t or u button to select SET .
4. Press the ENTER button.
• IPADDRESSscreenappears.
IP ADDRESS
192 . 168 . 0 . 10
0
OK
CLEAR
DEL
CANCEL
1234567 8 9
← →
5. Press the p, q,t, and u buttons to move the key
cursor, select the numbers to enter, and press the
ENTER button.
• Setthenumericvaluewithintherangefrom0to
255. However, set the numeric value for the final
octet within the range from 1 to 254.
← key: Shifting the position of enter cursor to
the left.
→ key: Shifting the position of enter cursor to
the right.
DEL key: Deleting the character in the position
of enter cursor for each character.
CLEAR key: Deleting all the entered
characters.
 previous next