Mitsubishi Electronics PK20 Projector User Manual


 
EN-13
When you use the battery, please observe the following
safety precautions:
Warning:
Dispose of used batteries according to your local
regulations.
Please do not put battery into fire or heat, otherwise it
may cause heating, fire, rupture or explosion.
Please do not put battery away or transport it with kind
of electrically conductive like necklace, hairpin, etc.,
otherwise it may cause heating, fire, leakage or
explosion.
Neither the positive nor negative terminal of batteries
can touch any metal, otherwise it may cause heating,
fire, rupture or explosion.
Please do not poke battery with needle, hit, decompose
or try to transform it, otherwise it may cause heating,
fire, rupture or explosion.
Please do not use or put battery near fire or under
high-temp environment, otherwise it may cause
heating, fire, rupture or explosion.
When the projector is off, the charger works as
a fast charging mode. It takes approximately 4
hours to complete charging.
When the projector is on, the charger works as
a slow charging mode. It takes approximately 8
hours to complete charging.
The average charge time: 500 times (Less than 50%
of charge).
For battery removal
Slide the battery lock switches on the two sides to remove
the battery from the projector.
Condition LAMP (Green) POWER (Red)
Stand-by. Off On
When the lamp is on. On Off
Indicator