Filter
Top Products
EN-38
Problem
Cause and solution
This is due to color breaking noise that occurs in a DLP system and is not a malfunction.
It occurs because of interference with the screen and isn’t a product malfunction.
Change the screen or readjust the focus of the projector.
Connect the cable’s plug with the external device’s connector firmly.
Keep the projector away from equipment generating interfering radio waves.
When the keystone adjustment is carried out, the image may not be displayed
correctly because of the type of input signal. This isn’t a product malfunction.
In this case, readjust the keystone so that the amount of keystone correction
is as small as possible.
Check that the cable connected to the external device isn’t broken.
This is caused by the computer being used. Contact the manufacturer of your
computer.
Match the output resolution of your computer with the resolution of the projector. For the
method to change the output resolution of the computer, contact the manufacturer
of your computer.
Some images and texts appear obscured during the keystone adjustment.
In such cases, use the projector without applying the keystone adjustment.
Select the appropriate brightness mode.
Change the brightness mode setting to Standard or Low.
Projected images appear wavy and distorted.
Tint in projected images is incorrect.
Projected images are obscured.
Fine streak pattern appears in projected images.
Only the motion areas in the images
supplied from the computer aren’t displayed.
Rainbow blurprojected images.
Color on the projected images is not good.
The white color looks greenish when the
brightness mode is set to high.