Mitsubishi Electronics PK20 Projector User Manual


 
EN-26
1 IMAGE
BRIGHTNESS MODE... Use to select the brightness mode.
• The white color looks greenish so that LED lights out become
maximum, when the brightness mode is set to high.
During the high brightness mode, color temperature is not
selectable.
• Choose Low mode to extend the battery wear.
CONTRAST .............. Use to adjust the image contrast. The contrast becomes higher as
the value increases.
BRIGHTNESS ........... Use to adjust the image brightness. The image becomes brighter
as the value increases.
COLOR TEMP............ Use to adjust the color temperature.
In USER mode, the intensity of R, G, B can be adjusted.
COLOR...................... Use to adjust the color intensity of the image.
TINT........................... Use to adjust the color balance of the image. The color balance
shifts to green as the value increases and shifts to purple as
the value decreases. (Available only when VIDEO or S-VIDEO
or COMPONENT (Y,CB,CR) is chosen as the source.)
* When the TV50 (PAL, SECAM) signal is input, TINT can’t be adjusted.
SHARPNESS............. Use to adjust the image sharpness. The image becomes sharp as the value increases. (Not available
with certain signals.)
GAMMA MODE.......... Use to set the gamma optimally.
DYNAMIC - Select when viewing images supplied from the computer.
STANDARD - Select when viewing images supplied from the video device.
THEATER - Select when viewing images of which brightness should be kept relatively low, such
as movies and music performance.