9. Close the supply cover completely.
10. Press 1if you are loading the same supply type. Press
eto start your application. Or, press 2 to load a
different supply type or size. You will see:
Supply Type?
1 = Synthetic
11. Press e if this is the correct supply type.
To change the supply type, use the arrow keys to scroll to
the correct supply type and then press e.
1 = High (recommended for synthetic supplies)
2 = Low (default- recommended for paper supplies)
3 = Specialty Paper
nDo not select Supply Type 4 since it requires a different
loading method.
You will see:
Supply Width?
WIDTH = 2.0
12. Press e if this is the correct width. -OR-
To change the width, use the arrow keys to scroll to the
correct width and then press e.
1 = 1.2
2 = 1.5
3 = 2.0
You will see:
ENTER STK LENGTH
4.0❚
Chapter 3. Loading Supplies
3-11