Filter
Top Products
3. Press > until you see:
Send
Serial Port
4. Press e.
From this point, you can set the following communications
parameters:
Baud Rate 19.2K, 9600*, 4800, 2400, 1200
Parity NONE, EVEN, ODD*, MARK, SPACE
Data Bits 7*, 8
Stop Bits 1*, 2
Flow Control NONE, XON/XOFF*, DTR, RTS, MODEM
Echo BEL Enable*, Disable
ENQ Polling Enable, Disable*
Resp Timeout 30* (seconds), 0 (minimum), 480 (maximum)
n Echo BEL, ENQ Polling and Response Timeout are all options
used by the application or set by the System Administrator.
5. Press < or > to display a parameter and press
e to select it.
6. Press < or > to display a value and press e to
select it.
* Factory set defaults.
6030 Operator’s Handbook
5-6