Filter
Top Products
ISI3334/4 Hardware/Driver Installation Manual
16
Figure 2-2. MultiModemISI/Auxiliary Module Components
Step Procedure
4a The default setting for the MultiModemISI’s base I/O address is
210 hex. The default value for the IRQ jumper is IRQ 10.
Choose the IRQ value by covering the appropriate pins with the
shorting plug (supplied). If your system requires a different
setting or if you are installing multiple cards, refer to Appendix B
for a table of valid address settings.
Note: Record any changes you make to these settings and keep
them handy for the software installation section in Chapter 3.