Filter
Top Products
ISI3334/4 Hardware/Driver Installation Manual
32
Table 3-4 (cont'd)
Step Explanation
10 The confirmation screen lists the values you have selected. If
these values are all correct, type Y and press <Enter> to
continue the installation process.
If there is an error in any of the values displayed, type N and the
first screen is re-displayed. You must then re-enter all of the
information for each card. Please refer to your notes if you have
multiple ISI cards to install.
When you accept the confirmation list (by pressing Y), a series
of messages are displayed while the driver is being installed and
the kernel rebuilt. When control returns to you, press <Enter> to
continue. The following message is displayed:
Installation complete
Press <Enter>.
11 Highlight Host and press <Enter>.
Remove the diskette from the floppy drive.
Highlight Exit and press <Enter>.
Type the following commands to reboot the system:
Type sync and press "Enter"
Type sync again and press "Enter"
Type haltsys and press "Enter"
At this time ISI Driver installation is complete.