Filter
Top Products
Chapter 3 - MultiModemISI Driver Installation
25
Table 3-2 (cont'd)
Step Procedure
Highlight Interrupt Request and click on Change Setting.
Select the proper IRQ value from the drop-down value list
(choose 10 to match the default setting for the ISI card) and click
OK.
13 Click on OK.
14 The following message appears (Note: although this message
appears, the settings you just entered match the defaults for the
ISI card. If you used the default settings, you must still power
the unit off):
You have made changes to your hardware settings.
Before your device will work properly, you must
shut down Windows, turn off your computers power,
and then change the settings on the hardware device
to match the settings you selected. For
information about changing settings, see your
hardware documentation.
Do you want to shut down now?
Remove the Installation diskette from your floppy drive and click
on Yes.
15 Power the unit off and then on again and then restart Windows
95.
16 Click on Start | Control Panel and then double click on the
Modems icon. Click on Add | Next.
Windows begins to detect the new Ports. When the detection is
complete, click on Next to accept the
Standard Modem
setting
for the selected port. The same screen will appear for each new
port detected. Click on Next to accept each port setting.