Filter
Top Products
ISI3334/4 Hardware/Driver Installation Manual
22
Table 3-1 (cont'd)
Step Procedure
8 The
Add Card
dialog box appears. Configure the following
parameters:
Number of Ports
Depending on the card you are installing, click on the correct
Number of Ports. Factory Default setting is 8 Ports).
I/O Base Address and IRQ
The software defaults to a setting of I/O Address = 200, IRQ = 3.
However, the factory default setting for all ISI Cards is I/O
Address = 210 and IRQ = 10. Click on the drop-down menus for
both parameters and choose I/O Address = 210 and IRQ = 10.
Click on Map Ports to configure and map individual ports.
9 The
ISI Port Mappings
dialog box appears. Configure each port
as desired. When finished, click on Done to complete the
installation.
At this time your installation in Windows NT 4.0 is complete.
The following icon is created and placed in the
Control Panel
:
In the future, just double click on this icon to add or configure ISI
cards on your system.
3.2.1 Removing the ISI Drivers in Windows NT 3.51
To remove the ISI drivers in Windows NT 3.51, open the Program
Manager and double click on ISICOM Driver and then double click
on Uninstall ISICOM. Follow the on-screen prompts to complete
the uninstall.
Note: In order to complete an uninstall, you must reboot your
system. Until you do so, certain elements, such as the
ISI Cards
Icon
, will still remain.