Filter
Top Products
Appendix B - ISI Testing Utilities
61
Whenever the Base IO Address and/or the IRQ values have been
changed, a parameter string must be added to the command line.
The string takes the form of [-Axxxx], where xxxx represents the new
Base IO Address value and [-Iy], where y represents the IRQ value
selected. Three potential combinations exist for the formatting of the
command line:
1) Changing only the Base IO Address setting the
command line takes the form:
3334TERM [-Axxxx]
2) Changing only the IRQ setting the command line takes
the form:
3334TERM [-Iy]
3) Changing both the Base IO Address and the IRQ settings
the command line takes the form:
3334TERM [-Axxxx] [-Iy]
For example, if the Base IO Address switch setting were changed to
2C0h, then the new command line would be:
A:\>3334TERM -A2C0
The following screen is displayed:
A:\>3334TERM -A2C0
Loading Firmware to ISI3334 located at address 2C0h
Loading default file: ISI3334.BIN
ISI3334 loading firmware.....
ISI3334 verifying firmware.....Verify OK.
ISI3334 afirmware loaded successfully.
ISI firmware loaded successfully...
Enter 1 to 8 for Eight ports ISI.
Enter port number ?