Filter
Top Products
ISI3334/4 Hardware/Driver Installation Manual
56
Appendix A - Base I/O Address Switch Settings
The table below provides the DIP-Switch settings for valid base I/O
addresses of the ISI4608. The switches can be set to "OPEN" (O in
the table below) or to "CLOSED" (C in the table below). Holding the
board with the switch facing you (reading numbers 1-8 left to right),
the "UP" position for the switch is OPEN, and the "DOWN" position
is CLOSED. "S1" below is labeled as "1" on the left side of the
switch and so on, through S8. For an example, turn to page B-2 and
compare the default switch settings with the address 200h listing.
Table A-1 Address Switch Settings
I/O Addr. DIP-Switch Settings
(hex) S1 S2 S3 S4 S5 S6 S7 S8
100 CCCCCO CC
108 O CCCCO CC
110 C O CCCO CC
118 OOCCCO CC
120 C C O CCO CC
128 O C O CCO CC
130 C OOCCO CC
138 OOOCCO CC
140 C C C O C O CC
148 O CCO C O CC
150 C O C O C O CC
158 OOC O C O CC
160 C C OOC O CC
168 O C OOC O CC
170 C OOOC O CC
178 OOOOC O CC
180 CCCCOOCC
188 O CCCOOCC
190 C O CCOOCC
198 OOCCOOCC
1A0 C C O C OOCC
1A8 O C O C OOCC
1B0 C OOC OOCC
1B8 OOOC OOCC
1C0 C C C OOOCC
1C8 O CCOOOCC