Filter
Top Products
Chapter 2 - Hardware Installation
17
Step Procedure
5 Install the MultiModemISI card(s) into the selected expansion
slot(s) in the same manner as any other add-on card, as
instructed in your computer’s documentation.
6 Fasten the retaining bracket to the computer chassis and
replace the cover.
7 Your MultiModemISI card(s) requires a modular
LINE JACK
.
This is typically an RJ11C or RJ11W jack, but could also be an
RJ12 or RJ13 jack. To connect the modem(s) to the PSTN
line(s), plug one end of the RJ11 cable(s) that is provided with
the modem into the LINE JACK connector(s) and the other end
into the phone-company-provided RJ11C or RJ11W modular
phone jack(s).
Note: Any cables connected to the computer must be shielded
to reduce interference.
8 Turn power on to the computer and refer to the manual that was
provided with the software you will be using with the
MultiModemISI in order to perform software installation
procedures.