Filter
Top Products
Chapter 3 - MultiModemISI Driver Installation
21
Table 3-1 (cont'd)
Step Procedure
4 Run the Setup Utility
Windows NT 3.51 Users
:
In the Program Manager, click on File | Run. In the command
line field, type A:\setup.
Follow the on-screen prompts to complete the installation of the
driver.
Windows NT 4.0 Users
:
Click on Start | Settings | Control Panel and then double click
on Add/Remove Programs. The
Add/Remove Programs
Properties
dialog box appears. Click on Install.
When the
Install Program From Floppy Disk or CD-ROM
dialog
box appears, insert the installation diskette into your floppy drive
and click on Next. In the
Command line for installation program
field, type A:\SETUP.EXE and click on Finish. The
Installation
Wizard
loads and the
Welcome
dialog box appears.
After you have read the license information, click on Next to
continue with the installation.
5 The
Destination Directory
dialog box appears. Click on Next to
accept the default
Destination Folder
, or click on
Browse to choose another location.
6 The following message appears:
The ISICOM Driver is installed successfully. You
can add the ISI cards.
Click on OK to add and configure the ISI card(s).
7 The
ISI Cards
dialog box appears. To add and configure new
cards, click on Add.