Filter
Top Products
ISI3334/4 Hardware/Driver Installation Manual
20
3.1 Introduction
The MultiModemISI ships with a NetWare
®
Loadable Module
(aioisix.nlm) for NetWare Connect communication Servers, and
drivers for Windows
®
95/NT and SCO
®
Open Server 5
®
. This chapter
will guide you through the installation of these drivers. Section 3.9
details the Multi-Tech Installation Script, which is executed by a
UNIX operating system.
As with all software, you should make a backup copy of the diskette
you received and use the copy for the installation. If you received a
3½" diskette, the capacity is 720KB. Consult your system manual for
instructions on disk copying. Also, if you have a numeric keypad,
and you intend to use it for the installation process, make sure you
have
"Num Lock"
on.
The process of installing a device driver consists of a modification to
your system. For this reason, only the "
super user
" (system
administrator) is allowed to perform the installation. If you cannot
login as the root, you must find the person in your organization who
has this authorization (i.e., password). To begin the driver
installation, login as root. Then proceed with the appropriate section.
3.2 Installing the ISI Driver in Windows NT
The following procedure describes how to install the ISI in a system
running Microsoft Windows NT 3.51 or NT 4.0, for use with Remote
Access Service (RAS) server, and other communications/fax server
type applications. Unless otherwise noted, these procedures refer to
both NT 3.51 and NT 4.0.
Table 3-1
ISI Driver Installation for Windows NT
Step Procedure
1 Configure and install the ISI Card in an available ISA slot as
described in the installation section of your Owner’s Manual.
2 Power up the NT system.
3 Insert the
Multi Modem ISI Driver for Windows NT
diskette.