Filter
Top Products
ISI3334/4 Hardware/Driver Installation Manual
34
Table 3-5 (cont'd)
Step Procedure
5 Repeat this process for each port on each board you have
installed. Record the settings you select for each port.
6 Using the device names created in the previous section, type the
following command for each port you wish to activate at this
time:
enable
ttylbx
7 Repeat this command for each port you wish to activate, using
the lower case letter for local terminal usage or upper case for
modem control.
Note: Only one of the options (i.e., modem control or local
terminal access) should be enabled for any port at one time. For
example, you cannot enable ttyl1a and then enable ttyl1A. To
change the status of a port, disable the current status (disable
ttyl1a) and then enable it for the desired status (enable ttyl1A).
3.6.1 Removing the Driver (SCO Open Server 5)
If you find it necessary to remove the Multi-Tech Serial Card Driver,
you should enter the configuration utility (i.e., custom for SCO Open
Server 5) and follow the instructions to remove the entire driver and
to rebuild the kernel without the ISI driver. If it is necessary to re-
install the driver, due to I/O address or IRQ overlap, you must
remove the driver first.