Filter
Top Products
© National Instruments Corporation C-1 NI 783xR User Manual
C
Using the SCB-68
Shielded Connector Block
This appendix describes how to connect input and output signals to the
NI 783xR with the SCB-68 shielded connector block.
The SCB-68 has 68 screw terminals for I/O signal connections. To use the
SCB-68 with the NI 783xR, you must configure the SCB-68 as a
general-purpose connector block. Refer to Figure C-1 for the
general-purpose switch configuration.
Figure C-1. General-Purpose Switch Configuration for the SCB-68 Terminal Block
After configuring the SCB-68 switches, you can connect the I/O signals to
the SCB-68 screw terminals. Refer to Appendix B, Connecting I/O Signals,
for the connector pin assignments for the NI 783xR. After connecting
I/O signals to the SCB-68 screw terminals, you can connect the SCB-68 to
the NI 783xR with the SH68-C68-S shielded cable.
S5 S4 S3
S1
S2