Filter
Top Products
Configuration Settings Required for Installing MP-RAS
NCR S16 Minitower Server Installing Network Operating System 11-15
Configuration Settings Required for
Installing MP-RAS
The configuration settings required for MP-RAS are listed in this section.
Hard Disk Group
• On-Board IDE Hard Disk Controller – Disabled
Parallel Port
• Enabled - base address 3BCh
Serial Port Group
• Port 1 – Enabled – address 03F8h
• Port 2 – Enabled – address 02F8h
Shadow Options
• E0000h - FFFFFh (System BIOS) – Enabled
• C0000h - C7FFFh (Video BIOS) – Enabled
• Memory at 15 MB-16 MB – Reserved for System Use
Cache
• L1 and L2 Cache – Enabled
• ECC/Parity Mode Selection – ECC
• Operation of ECC Correction Enabled
Other Configuration Settings
• Keyboard control – Enabled
• On Board PS/2 Mouse (IRQ 12) – Enabled
• Num Lock after boot – Enabled