Filter
Top Products
Configuring the SCSI Adapters
NCR S16 Minitower Server Installing Network Operating System 3-3
Configuring the SCSI Adapters
To configure the SCSI adapters, if connected to an Adaptec SCSI adapter,
follow these steps:
1. Press Ctrl + A when the following displays:
Adaptec AIC-7880 Ultra/Ultra W BIOS
Press <Ctrl><A> for SCSISelect (TM) Utility
Refer to Chapter 5 of the NCR S16 Minitower Server User Guide
(BST0-2142-00) for additional information about these settings.
2. Select SCSI Disk Utilities. Verify that all the SCSI devices are displayed
with correct information. If a low-level format on the hard disk drive is
needed, perform it now. Usually it is not needed.
3. Select Configure/View Host Adapter Settings and set the parameters as
follows:
SCSI Bus Interface Definitions
Host Adapter SCSI ID 7
SCSI Parity Checking Enabled
Host Adapter SCSI Term Low OFF/High ON
Boot Device Options:
Boot Target ID 0
Boot LUN Number 0
4. Select SCSI Device Configuration and set the parameters as follows:
SCSI Device ID (tab to desired device)
Initiate Sync Negotiation Yes
Maximum Sync Transfer Rate 20
Enable Disconnection Yes
* Initiate Wide Negotiation Yes
*For Wide devices only.