SCO Release 5: Installing TCP/IP Communications
8-10 Installing SCO UNIX
4. Select Add Protocol. Observe the following:
“Select one networking product to be added to:
smpw SMC8432, 8434 and 9332 Ethernet Adapter, board 0
HW smpw SMC 8432, 8434 and 9332 Ethernet Adapter, board 0
* - SCOTCP/IP
- SCOIPX/SPX”
5. Select the desired protocol, and press Enter.
6. If TCP/IP is selected, configure the TCP/IP settings.
7. After the desired protocol is successfully added, observe the following if
TCP/IP was selected (IPX/SPX may be slightly different):
“Current networking configuration:
HW SCO TCP/IP Loopback driver
SCO TCP/IP
- SCO NFS Runtime System
HW smpw SMC 8432, 8434 and 9332 Ethernet Adapter, Board 0
SCO TCP/IP
- SCO NFS Runtime System”
8. Relink the kernel and reboot for these changes to take effect.