Filter
Top Products
4-28 CRU Replacement and Server Upgrades
PCI Board
Retainer Bracket
Figure 4-30. Installing the PCI Board Retaining Bracket.
10. If installing a long PCI board, slide the bracket towards the rear of the
module to fasten the other edge of the board. Tighten the bracket screw. See
Figure 4-31.
Screw
Bracket
Figure 4-31. Adjusting the Card Bracket to Secure long PCI Boards.
11. Install the PCI module top cover, securing it with three screws.
12. Install the PCI module into the system cabinet following procedures
previously detailed in this chapter.
13. Connect the network cables and option board cables.
14. Power on the PCI module and reboot the system to ensure POST does not
display any error messages. If error messages are displayed, see the POST
error messages listed in Chapter 5.
15. Boot the PCI module using the NEC ESMPRO Manager or the ft series
utility to establish a dual configuration.