Filter
Top Products
Upgrading Your System 7-19
Installation
Install a DIMM in the following procedure.
IMPORTANT:
The server supports DIMMs of only the low-profile type
(30 mm (1.2 inches) in height). It does not support DIMMs exceeding the
specified height.
1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
2.
Pull out the server from the rack.
3.
Open the top cover.
4.
Remove the DIMM cover from the socket into which you are going to install a DIMM.
Open the levers at both ends of the socket. The cover is released from the socket.
IMPORTANT:
Keep the removed DIMM cover for future use.
5.
Push the DIMM straight into the socket.
NOTE:
Make sure of the orientation of the DIMM.
Each DIMM has a slit on the terminal side for preventing wrong insertion.
The levers automatically close when the DIMM is inserted into the socket.
Key slot
Key slot
Key
Key