Filter
Top Products
7-20 Upgrading Your System
6.
Install the components you removed in steps 1 to 3.
7.
Power on the server and verify that POST displays no error messages.
If POST displays an error message, take a note on the message and see the POST error
messages listed in Chapter 6.
8.
Start the SETUP and select [Advanced] → [Memory Configuration] to verify that the
installed DIMM shows the status "Installed". (See Chapter 3 or details.)
9.
Select "Yes" for [Reset Config Data] on the [Advanced] menu.
This setting is required to change the hardware configuration data. See Chapter 3 for
details.
10.
If Windows 2000 or Windows NT 4.0 is in use, set the paging file size to the
recommended value or a greater value as shown below.
– For Windows 2000: Total memory size × 1.5
– For Windows NT 4.0: Total memory size + 12MB
If NetWare is in use, reserve the disk space in the MS-DOS partition for a memory dump.