2-6 Setting Up Your System
ASSEMBLING THE RACK-MOUNT SYSTEM
This subsection provides the instructions for mounting the rack-mount server unit into a standard
EIA 19-inch rack cabinet.
This subsection also describes the removal procedures for the rack mount server unit from the 19-
inch rack cabinet.
WARNING
Observe the following instructions to safely use the server. Failure to follow
these instructions may result in death or serious personal injury.
■
Do not use the server in any unauthorized place.
■
Do not connect the ground line to a gas pipe.
CAUTION
Observe the following instructions to safely use the server. Failure to follow
these instructions may cause a fire, personal injury, or property damage.
■
Do not carry or install the server by a single person only.
■
Do not install the server where the load may be concentrated on a specific
point.
■
Do not install any component on the server by a single person only.
■
Do not pull a device out of the rack if the rack is unstable.
■
Do not leave more than one device pulled out from the rack.
■
Do not exceed the power rate of the wiring.