Filter
Top Products
Solving Problems 5-17
Messages and Beep Codes
Whenever a recoverable error occurs during POST, BIOS displays a message on
the video display screen and causes the speaker to beep twice as the message
appears. BIOS also issues a beep code (one long tone followed by two short
tones) during POST if the video configuration fails or if an external ROM
module does not checksum to zero.
At the beginning of each POST test routine, the BIOS outputs the test point
error code to I/O address 80h. If the BIOS detects a terminal error condition, it
halts POST after issuing a terminal error beep code signifying the test point
code and attempting to display the test point error code on the upper left corner
of the display screen. BIOS derives the beep code from the test point error code.
For example, a test point error code of 16 is indicated by a 1-2-2-3 beep code (a
single beep, a burst of two beeps, a burst of two beeps, and a burst of three
beeps). In addition, BIOS writes a value of 16 on the upper left corner of the
display screen and to I/O port 80h to enable debugging tools to identify the area
of failure.
The following table is a list of the test point error codes written at the start of
each POST test and the beep codes issued for terminal errors.
POST Tests
Code Beeps POST Routine Description
xx 1-1-1-1 There are no processors present in the system, or the processors are so
incompatible that the system BIOS cannot be run (like mismatched cache voltages).
02 Verify Real Mode
04 Get CPU type
06 Initialize system hardware
08 Initialize chipset registers with initial POST values
09 Set in POST flag
0A Initialize CPU registers
0C Initialize cache to initial POST values
0E Initialize I/O
0F Initialize the local bus IDE
10 Initialize Power Management
11 Load alternate registers with initial POST values
12 Restore CPU control word during warm boot
14 Initialize keyboard controller
16 1-2-2-3 BIOS ROM checksum
18 8254 timer initialization
1A 8237 DMA controller initialization