Filter
Top Products
700 Series Managed Switch User’s Guide for Software v2.1
Command Line Interface 6-13
SM-10004-02
FSM726(config)# diffserv <DSCP> <priority>
Where
<DSCP> = The DSCP value, which ranges from 0-63
<Priority> = The priority associated with the defined DSCP value. The available options are
normal and high
For example, suppose you want to set DSCP 33 to high, the command to do so would be:
FSM726(config)# diffserv 33 high
Exit
The exit command takes you out of the CLI mode by one level. For example, when you are in
configuration mode, and the prompt looks like
FSM726(config)#. By entering exit at the
prompt, you will exit the configuration mode and be taken back to the root level, where the prompt
looks like
FSM726#. When you enter the exit command at the root level, you will return to the
Main Menu of the switch.
Syntax
FSM726(config)# exit
Interface
The interface command allows you to configure each network interface of the switch. Items
such as the speed, duplex, and negotiation are configured in this mode. The command to enter the
interface mode is
Syntax
FSM726(config)# interface ethernet <x/y>
Where
<x/y> = x is the stack number, and y is the port number, which ranges from 1-26. Since FSM726
is not stackable, the value of x is always 1.
For example, suppose you want to configure port 8 on the switch, the command to do so would be:
FSM726(config)# interface ethernet 1/8