Filter
Top Products
700 Series Managed Switch User’s Guide for Software v2.1
Web-Based Management Interface 5-17
SM-10004-02
After making any changes to the screens within the Web Interface, you can save the changed
settings to NVRAM. If changes are not saved to NVRAM, then they will be lost during the next
switch reset or reboot.
Tools> Restore Factory Defaults
Figure 5-18: Save Configuration
This page allows you to restore the factory configuration by clicking "Restore", the system saves
the default settings (including password) into the NVRAM and resets itself.
Note: Network IP settings (i.e. IP address, Gateway Address, Network Mask) will not be affected
by the Restore command.