Filter
Top Products
700 Series Managed Switch User’s Guide for Software v2.1
5-14 Web-Based Management Interface
SM-10004-02
Click Apply to change the IP settings
Save Configuration to NVRAM and reset the system to implement the changes (Tools > Save
Configuration).
Set-up> Port Configuration
Figure 5-14: Port Configuration
This menu allows you can configure the status of each port.
• Port: The port number on the switch
• Name: The name of the port. This is a user-defined label.
• Link: A green triangle pointing up indicates a valid link, while a red triangle
pointing down indicates no link.
• On/Off: Indicates if the port is enabled or disabled by the Administrator.
• State: This refers to the Spanning Tree state of the port. Ports will be Blocking
(Blk), Listening (Lis), Learning (Lrn), Forwarding (Fwd) or Disabled
(Dis).
• Speed: Indicates the speed and duplex for the port. The possible entries are
Auto-negotiation (Auto); 10 Mbps half duplex (10M Half); 10 Mbps full
duplex (10M Full); 100 Mbps half duplex (100M Half); or 100 Mbps full
duplex (100M Full).