NETGEAR 700 Series Switch User Manual


 
700 Series Managed Switch User’s Guide for Software v2.1
Command Line Interface 6-15
SM-10004-02
<duplex operation> = one of three modes. auto, full, or half.
Exit
This command takes you out of Interface Configuration Mode and back to Configuration Mode.
Syntax
FSM726(config-if)# exit
Flow Control
This command enables flow control on this particular port.
Syntax
FSM726(config-if)# flow-ctrl
Help
The help command displays instructions on how to access help on the CLI.
Syntax
FSM726(config-if)# Help
To access Help on a specific command, you enter a question mark behind the command in
question, then a list of available options will be presented to you. For example, suppose you want
to know the available options to the command
cos. You would enter cos ?.
Mirror
You can designate a port for monitoring traffic from one or more other ports or of a single VLAN
configured on the switch. The switch monitors the network activity by copying all traffic from the
specified monitoring sources to the designated monitoring port, to which a network analyzer can
be attached
Syntax
FSM726(config-if)# mirror [source | monitor]
Where
[source | monitor] = Setting this particular port to be a mirror source or a mirror monitor