Filter
Top Products
108 Maintenance Releases
Procedure Steps
Step Action
1
Load the ServeRAID firmware upgrade CD into the CD-ROM
drive.
2
Log on to the server as the SSA role (ntsysadm).
3
Reboot the server.
4 If the operating system has been installed, change the boot
sequence so that the CD-ROM is the primary boot device by
doing the following:
•
When the BIOS information appears, press F12 to select the
boot sequence.
• Select CD-ROM as the primary boot device.
Otherwise, wait for the server to reboot.
The ServeRAID Manager screen appears. (This may take up to
two minutes.)
5 If an upgrade is not required, click OK to reboot server and
go to step 9. (The OK prompt does not always display. If this
happens, select File> Exit, and select Restart to reboot the
server.)
Otherwise, select Update to apply the update.
Attention: Do not power off the system during the update.
The ROM Update Wizard displays a firmware message.
6 Click OK.
7 Click Next to complete the update.
8 Click Finish.
The server reboots.
9 Remove the CD from the CD-ROM drive.
--End--
Application Server 5300
Nortel AS 5300 Installation
NN42040-300 01.04
4 November 2008
Copyright © 2007-2008 Nortel Networks
.