Filter
Top Products
54 Platform software installation
Configuring a system for individual accounts
Procedure Steps
Step Action
1 During the Linux operating system installation process, the
system displays the following prompt:
Would you like to create pre-configured accounts
for this system? (Y/N) [N]?
2
Reply N to create an individual account. (If you reply Y to this
prompt, the system configures preconfigured accounts.)
The installer displays the SSA (System Security Administrator)
account configuration screen.
3
Enter a name for the SSA account. Ensure the name meets the
requirements displayed on-screen.
The installer displays the account method confirmation screen.
4 Do one of the following:
Reply Y to accept the account method confirmation.
OR
Reply N to go back to the User Accounts screen and change
selections.
After the account confirmation is accepted, the installer displays
the prompt to create the password for the SSA account. The
password limitations and requirements appear on-screen.
5
Enter a password for the SSA account. Ensure the password
meets the requirements displayed on-screen.
The installer displays the system accounts configuration screen.
6 Create passwords for each system account as prompted for by
the installer.
The installer displays the following message:
System Configuration Complete
7 Press Enter to accept the configuration.
The installer applies the system configurations. This may take
several minutes.
After the configuration has been applied, the server reboots.
Login access is available at the physical console, through RSA-II
remote control (if configured), and available SSH.
8 If applicable, install platform patches.
--End--
Application Server 5300
Nortel AS 5300 Installation
NN42040-300 01.04
4 November 2008
Copyright © 2007-2008 Nortel Networks
.